ServicesUV Water Purification
UV Water Purification in Steiner Ranch
We install point-of-entry UV systems that expose every gallon entering your home to UV-C light, neutralizing 99.9% of bacteria. No chemicals go into your water, nothing changes its taste, and the lamp needs changing only once a year. We test first, size the unit to your flow and protect your floors while we work.

What a UV System Does, and What It Doesn't
Inside the system, water moves through a stainless steel chamber built around a low-pressure UV lamp. The lamp sits in a clear quartz sleeve, so it never contacts the water. It emits UV-C at 254 nanometers, a wavelength that damages the genetic material microbes need to reproduce, and a microbe that can't copy itself can't make anyone sick. That includes E. coli and coliform bacteria.
Disinfection is the only job UV does. Chlorine, lead, hardness and sediment pass straight through, and nothing stays behind in your pipes to keep working downstream. So we usually put a sediment prefilter in front of it, and when your test shows a need, Whole-Home Filtration or a softener goes upstream too. UV performs best as the final stage before water reaches your taps.
We test your water before suggesting a unit, and we tell you straight whether UV adds meaningful protection for your home or whether a different stage would do more for you.
What Your UV Installation Includes
Water test and sizing
We measure hardness, iron, manganese and turbidity, since each one changes how much light actually reaches the water. Then we match the chamber to your peak demand in gallons per minute, so the dose stays full even with two showers and the dishwasher running together.
Sediment prefilter
Upstream of the chamber we fit a cartridge housing rated at 5 microns. Suspended particles cast tiny shadows where bacteria can hide from the light, so we treat this stage as required, not an add-on.
Chamber, lamp and controller
The stainless chamber mounts vertically or horizontally, whichever suits your space, and the ballast plugs into a grounded outlet. The controller counts down remaining lamp life and alarms if the lamp quits.
Bypass valves
A three-valve bypass lets us change the lamp or clean the sleeve without shutting off water to the rest of your home.
Plumbing sanitization
The light only treats water moving through the chamber, not the pipes already past it. After startup we sanitize the downstream lines once, so the system starts with clean plumbing.
Signs UV Purification Belongs on Your Line
Coliform on a lab report
When test results come back showing E. coli or total coliform present, UV is the most direct fix that adds no chemicals. We retest once the system is running to confirm the result is clean.
Repeated boil-water notices
Some households want a backup barrier for the days the utility issues an advisory. A correctly sized UV unit neutralizes 99.9% of the bacteria those notices warn about.
Someone in your home is immune-compromised
Babies, older relatives and anyone taking certain medications are more vulnerable to waterborne pathogens. UV adds a layer of protection and leaves taste alone.
You're adding a filter that removes chlorine
A carbon tank takes out the disinfectant your utility adds. Placing UV after the carbon puts protection back for the water sitting in your lines.
How the Installation Day Runs
- 1
Walkthrough with you
We confirm where the main line enters your home, where the unit will mount and which outlet will power it. You'll know how long the water will be off before we close a valve.
- 2
Protecting the work area
We lay drop cloths from the door to the equipment and wear shoe covers inside. If the main line runs along an exterior wall, we keep tools and fittings off your beds and mulch.
- 3
Plumbing and startup
We cut in the bypass, prefilter and chamber, pressure-test every joint and let the lamp warm up before water flows through. Then we sanitize the downstream lines and flush every fixture.
- 4
Handoff and cleanup
We show you the lamp-life display and how to use the bypass, label the cartridge, and haul away every scrap of pipe and packaging. You get a written note of when the lamp and sleeve are due for service.
What Moves the Cost of a UV System
Most of the price comes from how much water the system must treat at once and what has to go in front of it. We give you a written, line-item quote by phone after your free water test, so you see each part before you decide. Installation is free.
- Flow rate
- A chamber rated for a higher gallons-per-minute flow uses a longer lamp and a larger vessel. Homes with more bathrooms need more capacity to keep the UV dose high enough.
- Pretreatment needs
- Hard water scales the quartz sleeve, and iron above about 0.3 ppm stains it. If your test shows either, a softener or iron filter ahead of the UV adds to the job but keeps the lamp effective.
- Monitoring features
- A basic unit has a lamp-failure alarm. A unit with a UV intensity sensor measures the light actually reaching the water and costs more.
- Space and electrical access
- A tight closet or a mount far from an outlet means extra fittings or a dedicated circuit.
UV Purification Questions We Hear
Something not covered here? (512) 710-0237
Will UV change the taste or smell of my water?
No. UV light puts nothing into the water and takes nothing out, so it tastes and smells the same after the install as it does now. A chlorine flavor calls for carbon filtration, and we can add a carbon stage ahead of the UV chamber.
When does the lamp have to be replaced?
Once a year, even when it still glows. After about 9,000 hours of constant use, its UV-C output falls off well before the visible light dims. We clean the quartz sleeve during the same visit, because film on the glass blocks the light.
Is the lamp on around the clock?
Yes. The lamp takes time to reach full strength, so cycling it on and off would let some water pass without full treatment. Its power draw is close to that of a regular light bulb.
What if the power fails?
Without power the lamp shuts off, and water can flow through untreated. When the power returns, run the cold taps for a few minutes. Some controllers include a solenoid valve that stops flow during an outage, and we can go over whether one is worth it for your home.
Does UV do the job of my other filters?
No. UV handles living microbes only. Sediment, hardness, metals and chemicals each call for a separate stage, which is why we test the water before proposing a setup.

Find Out Whether UV Fits Your Water
We'll test your water free, explain what the results mean for your home and quote only the stages you need. Your floors stay covered and your questions get straight answers.